static int io[MAX_NE_CARDS];
static int irq[MAX_NE_CARDS];
static int bad[MAX_NE_CARDS];
+static u32 ne_msg_enable;
#ifdef MODULE
module_param_array(io, int, NULL, 0);
module_param_array(irq, int, NULL, 0);
module_param_array(bad, int, NULL, 0);
+module_param_named(msg_enable, ne_msg_enable, uint, (S_IRUSR|S_IRGRP|S_IROTH));
MODULE_PARM_DESC(io, "I/O base address(es),required");
MODULE_PARM_DESC(irq, "IRQ number(s)");
MODULE_PARM_DESC(bad, "Accept card(s) with bad signatures");
+MODULE_PARM_DESC(msg_enable, "Debug message level (see linux/netdevice.h for bitmap)");
MODULE_DESCRIPTION("NE1000/NE2000 ISA/PnP Ethernet driver");
MODULE_LICENSE("GPL");
#endif /* MODULE */
if (base_addr > 0x1ff) { /* Check a single specified location. */
int ret = ne_probe1(dev, base_addr);
if (ret)
- printk(KERN_WARNING "ne.c: No NE*000 card found at "
- "i/o = %#lx\n", base_addr);
+ netdev_warn(dev, "ne.c: No NE*000 card found at "
+ "i/o = %#lx\n", base_addr);
return ret;
}
else if (base_addr != 0) /* Don't probe at all. */
/* found it */
dev->base_addr = pnp_port_start(idev, 0);
dev->irq = pnp_irq(idev, 0);
- printk(KERN_INFO "ne.c: ISAPnP reports %s at i/o %#lx, irq %d.\n",
- (char *) isapnp_clone_list[i].driver_data,
- dev->base_addr, dev->irq);
+ netdev_info(dev,
+ "ne.c: ISAPnP reports %s at i/o %#lx, irq %d.\n",
+ (char *) isapnp_clone_list[i].driver_data,
+ dev->base_addr, dev->irq);
if (ne_probe1(dev, dev->base_addr) != 0) { /* Shouldn't happen. */
- printk(KERN_ERR "ne.c: Probe of ISAPnP card at %#lx failed.\n", dev->base_addr);
+ netdev_err(dev,
+ "ne.c: Probe of ISAPnP card at %#lx failed.\n",
+ dev->base_addr);
pnp_device_detach(idev);
return -ENXIO;
}
int neX000, ctron, copam, bad_card;
int reg0, ret;
static unsigned version_printed;
+ struct ei_device *ei_local = netdev_priv(dev);
if (!request_region(ioaddr, NE_IO_EXTENT, DRV_NAME))
return -EBUSY;
}
}
- if (ei_debug && version_printed++ == 0)
- printk(KERN_INFO "%s%s", version1, version2);
+ if ((ne_msg_enable & NETIF_MSG_DRV) && (version_printed++ == 0))
+ netdev_info(dev, "%s%s", version1, version2);
- printk(KERN_INFO "NE*000 ethercard probe at %#3lx:", ioaddr);
+ netdev_info(dev, "NE*000 ethercard probe at %#3lx:", ioaddr);
/* A user with a poor card that fails to ack the reset, or that
does not have a valid 0x57,0x57 signature can still use this
while ((inb_p(ioaddr + EN0_ISR) & ENISR_RESET) == 0)
if (time_after(jiffies, reset_start_time + 2*HZ/100)) {
if (bad_card) {
- printk(" (warning: no reset ack)");
+ pr_cont(" (warning: no reset ack)");
break;
} else {
- printk(" not found (no reset ack).\n");
+ pr_cont(" not found (no reset ack).\n");
ret = -ENODEV;
goto err_out;
}
}
if (bad_clone_list[i].name8 == NULL)
{
- printk(" not found (invalid signature %2.2x %2.2x).\n",
+ pr_cont(" not found (invalid signature %2.2x %2.2x).\n",
SA_prom[14], SA_prom[15]);
ret = -ENXIO;
goto err_out;
}
#else
- printk(" not found.\n");
+ pr_cont(" not found.\n");
ret = -ENXIO;
goto err_out;
#endif
mdelay(10); /* wait 10ms for interrupt to propagate */
outb_p(0x00, ioaddr + EN0_IMR); /* Mask it again. */
dev->irq = probe_irq_off(cookie);
- if (ei_debug > 2)
- printk(" autoirq is %d\n", dev->irq);
+ if (netif_msg_probe(ei_local))
+ pr_cont(" autoirq is %d", dev->irq);
} else if (dev->irq == 2)
/* Fixup for users that don't know that IRQ 2 is really IRQ 9,
or don't know which one to set. */
dev->irq = 9;
if (! dev->irq) {
- printk(" failed to detect IRQ line.\n");
+ pr_cont(" failed to detect IRQ line.\n");
ret = -EAGAIN;
goto err_out;
}
share and the board will usually be enabled. */
ret = request_irq(dev->irq, eip_interrupt, 0, name, dev);
if (ret) {
- printk (" unable to get IRQ %d (errno=%d).\n", dev->irq, ret);
+ pr_cont(" unable to get IRQ %d (errno=%d).\n", dev->irq, ret);
goto err_out;
}
}
#endif
- printk("%pM\n", dev->dev_addr);
+ pr_cont("%pM\n", dev->dev_addr);
ei_status.name = name;
ei_status.tx_start_page = start_page;
dev->netdev_ops = &eip_netdev_ops;
NS8390p_init(dev, 0);
+ ei_local->msg_enable = ne_msg_enable;
ret = register_netdev(dev);
if (ret)
goto out_irq;
- printk(KERN_INFO "%s: %s found at %#lx, using IRQ %d.\n",
- dev->name, name, ioaddr, dev->irq);
+ netdev_info(dev, "%s found at %#lx, using IRQ %d.\n",
+ name, ioaddr, dev->irq);
return 0;
out_irq:
static void ne_reset_8390(struct net_device *dev)
{
unsigned long reset_start_time = jiffies;
+ struct ei_device *ei_local = netdev_priv(dev);
- if (ei_debug > 1)
- printk(KERN_DEBUG "resetting the 8390 t=%ld...", jiffies);
+ netif_dbg(ei_local, hw, dev, "resetting the 8390 t=%ld...\n", jiffies);
/* DON'T change these to inb_p/outb_p or reset will fail on clones. */
outb(inb(NE_BASE + NE_RESET), NE_BASE + NE_RESET);
/* This check _should_not_ be necessary, omit eventually. */
while ((inb_p(NE_BASE+EN0_ISR) & ENISR_RESET) == 0)
if (time_after(jiffies, reset_start_time + 2*HZ/100)) {
- printk(KERN_WARNING "%s: ne_reset_8390() did not complete.\n", dev->name);
+ netdev_err(dev, "ne_reset_8390() did not complete.\n");
break;
}
outb_p(ENISR_RESET, NE_BASE + EN0_ISR); /* Ack intr. */
if (ei_status.dmaing)
{
- printk(KERN_EMERG "%s: DMAing conflict in ne_get_8390_hdr "
- "[DMAstat:%d][irqlock:%d].\n",
- dev->name, ei_status.dmaing, ei_status.irqlock);
+ netdev_err(dev, "DMAing conflict in ne_get_8390_hdr "
+ "[DMAstat:%d][irqlock:%d].\n",
+ ei_status.dmaing, ei_status.irqlock);
return;
}
{
#ifdef NE_SANITY_CHECK
int xfer_count = count;
+ struct ei_device *ei_local = netdev_priv(dev);
#endif
int nic_base = dev->base_addr;
char *buf = skb->data;
/* This *shouldn't* happen. If it does, it's the last thing you'll see */
if (ei_status.dmaing)
{
- printk(KERN_EMERG "%s: DMAing conflict in ne_block_input "
- "[DMAstat:%d][irqlock:%d].\n",
- dev->name, ei_status.dmaing, ei_status.irqlock);
+ netdev_err(dev, "DMAing conflict in ne_block_input "
+ "[DMAstat:%d][irqlock:%d].\n",
+ ei_status.dmaing, ei_status.irqlock);
return;
}
ei_status.dmaing |= 0x01;
this message you either 1) have a slightly incompatible clone
or 2) have noise/speed problems with your bus. */
- if (ei_debug > 1)
+ if (netif_msg_rx_status(ei_local))
{
/* DMA termination address check... */
int addr, tries = 20;
break;
} while (--tries > 0);
if (tries <= 0)
- printk(KERN_WARNING "%s: RX transfer address mismatch,"
- "%#4.4x (expected) vs. %#4.4x (actual).\n",
- dev->name, ring_offset + xfer_count, addr);
+ netdev_warn(dev, "RX transfer address mismatch,"
+ "%#4.4x (expected) vs. %#4.4x (actual).\n",
+ ring_offset + xfer_count, addr);
}
#endif
outb_p(ENISR_RDC, nic_base + EN0_ISR); /* Ack intr. */
unsigned long dma_start;
#ifdef NE_SANITY_CHECK
int retries = 0;
+ struct ei_device *ei_local = netdev_priv(dev);
#endif
/* Round the count up for word writes. Do we need to do this?
/* This *shouldn't* happen. If it does, it's the last thing you'll see */
if (ei_status.dmaing)
{
- printk(KERN_EMERG "%s: DMAing conflict in ne_block_output."
- "[DMAstat:%d][irqlock:%d]\n",
- dev->name, ei_status.dmaing, ei_status.irqlock);
+ netdev_err(dev, "DMAing conflict in ne_block_output."
+ "[DMAstat:%d][irqlock:%d]\n",
+ ei_status.dmaing, ei_status.irqlock);
return;
}
ei_status.dmaing |= 0x01;
/* This was for the ALPHA version only, but enough people have
been encountering problems so it is still here. */
- if (ei_debug > 1)
+ if (netif_msg_tx_queued(ei_local))
{
/* DMA termination address check... */
int addr, tries = 20;
if (tries <= 0)
{
- printk(KERN_WARNING "%s: Tx packet transfer address mismatch,"
- "%#4.4x (expected) vs. %#4.4x (actual).\n",
- dev->name, (start_page << 8) + count, addr);
+ netdev_warn(dev, "Tx packet transfer address mismatch,"
+ "%#4.4x (expected) vs. %#4.4x (actual).\n",
+ (start_page << 8) + count, addr);
if (retries++ == 0)
goto retry;
}
while ((inb_p(nic_base + EN0_ISR) & ENISR_RDC) == 0)
if (time_after(jiffies, dma_start + 2*HZ/100)) { /* 20ms */
- printk(KERN_WARNING "%s: timeout waiting for Tx RDC.\n", dev->name);
+ netdev_warn(dev, "timeout waiting for Tx RDC.\n");
ne_reset_8390(dev);
NS8390p_init(dev, 1);
break;
retval = platform_driver_probe(&ne_driver, ne_drv_probe);
if (retval) {
if (io[0] == 0)
- printk(KERN_NOTICE "ne.c: You must supply \"io=0xNNN\""
- " value(s) for ISA cards.\n");
+ pr_notice("ne.c: You must supply \"io=0xNNN\""
+ " value(s) for ISA cards.\n");
ne_loop_rm_unreg(1);
return retval;
}
projects / linux-drm-fsl-dcu.git / blobdiff