15. SCSI problem troubleshooting
15.1 Problem tracking
15.2 Understanding hardware error reports
-16. Synchonous transfer negotiation tables
+16. Synchronous transfer negotiation tables
16.1 Synchronous timings for 53C875 and 53C860 Ultra-SCSI controllers
16.2 Synchronous timings for fast SCSI-2 53C8XX controllers
17. Serial NVRAM support (by Richard Waltham)
ftp://ftp.symbios.com/
-Usefull SCSI tools written by Eric Youngdale are available at tsx-11:
+Useful SCSI tools written by Eric Youngdale are available at tsx-11:
ftp://tsx-11.mit.edu/pub/linux/ALPHA/scsi/scsiinfo-X.Y.tar.gz
ftp://tsx-11.mit.edu/pub/linux/ALPHA/scsi/scsidev-X.Y.tar.gz
support by the driver of this feature at linux start-up and enable
this feature after boot-up only for devices that support it safely.
-CONFIG_SCSI_NCR53C8XX_PROFILE_SUPPORT (default answer: n)
- This option must be set for profiling information to be gathered
- and printed out through the proc file system. This features may
- impact performances.
-
CONFIG_SCSI_NCR53C8XX_IOMAPPED (default answer: n)
Answer "y" if you suspect your mother board to not allow memory mapped I/O.
May slow down performance a little. This option is required by
A boot setup command for the ncr53c8xx (sym53c8xx) driver begins with the
driver name "ncr53c8xx="(sym53c8xx). The kernel syntax parser then expects
-an optionnal list of integers separated with comma followed by an optional
-list of comma-separated strings. Example of boot setup command under lilo
+an optional list of integers separated with comma followed by an optional
+list of comma-separated strings. Example of boot setup command under lilo
prompt:
lilo: linux root=/dev/hda2 ncr53c8xx=tags:4,sync:10,debug:0x200
Some scsi boards use a 875 (ultra wide) and only supply narrow connectors.
If you have connected a wide device with a 50 pins to 68 pins cable
converter, any accepted wide negotiation will break further data transfers.
- In such a case, using "wide:0" in the bootup command will be helpfull.
+ In such a case, using "wide:0" in the bootup command will be helpful.
10.2.14 Differential mode
diff:0 never set up diff mode
ncr53c8xx=safe:y,mpar:y
ncr53c8xx=safe:y
-My personnal system works flawlessly with the following equivalent setup:
+My personal system works flawlessly with the following equivalent setup:
ncr53c8xx=mpar:y,spar:y,disc:y,specf:1,fsn:n,ultra:2,fsn:n,revprob:n,verb:1\
tags:32,sync:12,debug:0,burst:7,led:1,wide:1,settle:2,diff:0,irqm:0
15.1 Problem tracking
Most SCSI problems are due to a non conformant SCSI bus or to buggy
-devices. If infortunately you have SCSI problems, you can check the
+devices. If unfortunately you have SCSI problems, you can check the
following things:
- SCSI bus cables
You are not required to decode and understand them, unless you want to help
maintain the driver code.
-16. Synchonous transfer negotiation tables
+16. Synchronous transfer negotiation tables
Tables below have been created by calling the routine the driver uses
for synchronisation negotiation timing calculation and chip setting.